Guangdong Endurance Electronic Equipment Co., LtdMain products: testing machine
National Service Hotline :0086-13416787649 Wechat
Official wechat
Mobile
Mobile

No Ignition at Low Flow and Hot-Cold Swings When Two Taps Run? NL-GWH-4 Gas Water Heater Minimum Activation Flow and Outlet Temperature Bench (pump test bench)

Popularity:8Time of publication:2026/11/16 9:22:21

Two experience metrics of a gas water heater are hard to pin down on a complete unit. The first is minimum activation flow: below that flow the water-gas linkage or flow sensor gives no signal, the burner never lights, and a small summer shower stalls right there. The second is outlet temperature response: any change of inlet temperature, inlet flow or gas pressure forces a new balance, and the overshoot, settling time and band width are what the user feels as hot-cold swinging. Factory checks measure one steady value at fixed flow and fixed inlet temperature; the scatter of the activation threshold, the step-response curve and the draw-sharing coupling of two taps are never measured on a bench: how low before it stops firing, how many degrees it spikes when pressure drops, how far temperature swings with two taps open — all left to the installer's hand.

What the NL-GWH-4 minimum activation flow and outlet temperature bench measures

  • Six stations with quick-change water circuits for forced-draft, condensing and recirculating models (the whole-appliance branch of our pump test bench supply lines)
  • Minimum activation flow: flow stepped down from 6 to 1 L/min, ignition moment, failed attempts and re-ignition repeatability per step
  • Outlet temperature step response: setpoint step and inlet temperature step as two disturbances, overshoot, settling time and band width per run
  • Flow disturbance response: inlet flow driven with sine and random spectra, tracking error and control lag on one chart
  • Multi-tap coupling: main and branch draw together, main-line swing and recovery time logged at every branch open and close
  • Gas side: gas pressure and valve position logged together, proportional valve response and air-gas ratio adjustment broken out
  • Inlet temperature matrix: 5–35 °C in steps, cold-start behaviour and over-temperature protection both exercised
  • Thermal efficiency: to GB 20665 at rated and part load, on the same sheet as the response data
  • Flue gas: CO, CO2 and O2 sampled together, ratio faults and incomplete combustion located
  • Low pressure and frost protection: inlet 0.02–0.6 MPa in steps, low-pressure start and drain-down sequences reproduced
  • Endurance path: ten thousand start-stop cycles, ignition reliability, electrode fouling and flow sensor drift per stage
  • Supply accuracy: circulating loop held on a pump performance test constant-pressure constant-flow basis, pressure ripple excluded from response data
  • Level channels: tank and expansion vessel levels on level sensor life test lines, dry-run protection reproduced
  • Cross-category: flow and temperature methods for water-using appliances shared with dishwasher test equipment and washing machine test equipment lines
  • Barcode binding, activation threshold, overshoot, settling time and efficiency exported per run for model and circuit traceability

Applicable standards

Household gas instantaneous water heaters to GB 6932, gas tightness, combustion, hot water output and temperature control to its relevant clauses; energy efficiency to GB 20665; appliance safety to the relevant clauses of GB 4706.1. Limits, draw programmes and disturbance spectra can follow the customer standard, sampling to GB/T 2828.

Stations and throughput

Six stations map one model's activation threshold and temperature response in a day and complete an inlet-temperature and flow-disturbance matrix in a week. “Feel the water on site” becomes a unit report with threshold, overshoot and settling time. Air-gas ratio release, controller tuning and after-sales hot-cold complaints all settle on one bench.

Manufacturer

Guangdong Endurance Electronic Equipment Co., Ltd. — a non-standard testing equipment manufacturer of gas water heater minimum activation flow and outlet temperature benches, pump test bench and pump performance test ranges, level sensor life test machines, dishwasher test equipment and washing machine test equipment.

Keywords: pump test bench, pump performance test, level sensor life test, dishwasher test equipment, washing machine test equipment.

Recommended products

Ranking of similar articles

Latest news articles