Guangdong Endurance Electronic Equipment Co., LtdMain products: testing machine
National Service Hotline :0086-13416787649 Wechat
Official wechat
Mobile
Mobile

The Fridge Hums for Ages and Never Cools, Yet a New Starter Fixes It? NL-RSP-4 Compressor PTC Starter and Overload Protector Bench (washing machine test equipment)

Popularity:9Time of publication:2026/11/16 9:11:35

A fridge compressor starts and protects itself through two small parts. The PTC starter uses its own resistance-temperature behaviour to bypass the run winding at start-up, then heats, rises in resistance and drops out within seconds; the overload protector opens a bimetal on current and temperature together. Scatter in either part shows up on the appliance as a compressor that will not start, starts slowly, trips repeatedly, or hums without cooling. Incoming inspection usually puts a multimeter on one cold resistance — the parameters that actually decide the outcome, the resistance-temperature curve, the Curie point, the starting current peak, the trip current and reset time, are not measured. Fitting to a machine and listening is slow, so a lot gets a few samples and no scatter figure. That a swapped starter cures the unit already proves the fault sits in the part, but the judgement never gets numbers behind it.

What the NL-RSP-4 PTC starter and overload protector bench measures

  • Eight stations with quick-change nests for PTC starters, current-relay starters and external or internal overload protectors (the refrigeration branch of our washing machine test equipment component lines)
  • Resistance-temperature behaviour: cold resistance, Curie point and rise curve measured point by point in a chamber, lot histogram plotted directly
  • Start-up: starting current peak, start time and bypass drop-out logged together against a programmable compressor load
  • Cool-down: restart intervals from 30 to 300 s in steps, the failure rate of a hot restart tabulated per step
  • Protector trip: trip current, trip time, reset time and reset temperature per unit, bimetal consistency tabulated
  • Locked rotor: trip count and contact erosion under locked-rotor current, contact resistance growth plotted per cycle
  • Thermal link: starter body temperature rise logged with the resistance curve, drop-out shift in a hot compressor bay reproduced
  • Voltage boundary: supply stepped down from rated, no-start and slow-start critical voltages per unit
  • Endurance path: one hundred thousand start-protect cycles, curve shift, contact erosion and case deformation per stage
  • Incoming grading: PTC disc, bimetal and contact material as a sampling matrix, supplier lot consistency reported
  • Equivalent load: compressor modelled with programmable locked rotor and back-EMF, one bench covering different displacements
  • Supply and loop basis: cooling water and oil circuits held on pump test bench and pump performance test flow bases, thermal data free of circuit variation
  • Level channels: chamber and cooling loop levels on level sensor life test lines, dry-run protection told apart from protector trips
  • Cross-category: component safety and endurance methods shared with dishwasher test equipment lines
  • Barcode binding, resistance curve, starting current, trip points and endurance decay exported per run for part lot and supplier traceability

Applicable standards

Household refrigerator performance to GB/T 8059 (IEC 62552 basis), cooling capability and energy to its relevant clauses; appliance safety to GB 4706.1 and GB 4706.13 (IEC 60335-2-24 basis); starter and protector limits can follow the customer standard and the supplier specification, sampling to GB/T 2828.

Stations and throughput

Eight stations screen a starter lot across resistance curve and trip points in a day and complete a new part's decay record to one hundred thousand cycles in a week. “Fit it and listen” becomes a component report with curves, currents and trip points. Incoming grading, supplier switching and after-sales no-cooling complaints all settle on one bench.

Manufacturer

Guangdong Endurance Electronic Equipment Co., Ltd. — a non-standard testing equipment manufacturer of compressor PTC starter and overload protector benches, washing machine test equipment, dishwasher test equipment, pump test bench ranges, pump performance test systems and level sensor life test machines.

Keywords: pump test bench, pump performance test, level sensor life test, dishwasher test equipment, washing machine test equipment.

Recommended products

Ranking of similar articles

Latest news articles