Slides seize or sag before their rated life and after-sales keeps replacing them; manual pull tests are slow and uncontrolled; destructive force values and push-pull forces cannot be measured by hand; and drawer sizes vary so fixtures rarely fit.
The machine endurance-tests slides mounted on furniture drawers and can also apply set force values for destructive tests and measure drawer push-pull force. Endurance mode places a load inside the drawer and repeatedly pulls it out and closes it through a set stroke, count and dwell time, then the slide is judged; destructive mode applies a defined force to the furniture part to check damage under load. Stroke 0-600mm; drawer height 150-1300mm adjustable; load range 500N with settable load-stop; speed 5-15 cycles/min; footprint 900x1500x1560mm; air supply above 0.5MPa. Force sensor plus PLC control; ball screw with manual height adjustment of the working position; imported-brand pneumatic components and cylinders; unmanned long-duration operation; dedicated standard test fixtures included.
Endurance life verification of furniture drawer slides; factory inspection and type testing at slide hardware makers; incoming sampling and R&D comparison at furniture plants; furniture hardware durability testing at institutes
Guangdong Endurance Electronic Equipment Co., Ltd provides non-standard customization, drawing confirmation, factory acceptance, on-site installation and commissioning, operation training and lifetime technical service; 12-month warranty and lifetime spare parts supply. Tel: 0760-88500902 / 13416787649. Web: en.zsnaili.com.
QQ
Service call
Back to the top